27, Jalan Badik 17,
Taman Puteri Wangsa,
81800 Ulu Tiram,
Johor, Malaysia.
+607-8673811
BRD01 MAG Loop Detector
Previous | 4 / 6 | Next |
RM 0.00
BRD01 – MAG STANDARD VEHICLE LOOP DETECTOR
Discontinuous ( EOL )
BRD01 is a single channel loop detector typically installed underneath the floor to detect a vehicle passing through.
It supports adjustable 3 levels of sensitivity to cater to different heights of vehicle.
Description
In any card access system, the reader will trigger a barrier gate to open upon flashing a valid card.
If a loop detector is used, the vehicle will trigger the system when it goes over the inductive loop,
which is usually hidden in the ground. This sends a signal to the barrier gate controller to close as soon
as the vehicle exit the lane. As the loop is buried in the ground, it is a safe and secure system to use.
The loop detector is reliable and cannot be tampered with easily, as the main control is typically hidden inside the barrier gate.
Avoid arm hitting a car
A loop detector can also help to prevent the gates from closing too soon.
When the vehicle is passing through, it will break the circuit and tell the gate to remain open,
preventing it from closing on the car. When the barrier arm is descending,
BRD01 will trigger the arm to auto-reverse if it detects another vehicle entering to avoid hitting it.
No human shall pass through barrier gate lane
BRD01 is a metal detector and cannot detect humans. BRD01 will not be able to trigger the barrier arm
to descend if a human walk past through. To avoid this problem, another BRD01 can be installed to ensure
there is a vehicle before activating the reader to accept card reading.
Cannot go in from the opposite direction
In some cases where there is no card access system, BRD01 can be used to automatically trigger the barrier gate
to open upon detecting the presence of any vehicle. By installing the loop coil in 1 direction,
you can effectively block any vehicle trying to enter from the other side.